- Doc
- TF-SS-PRT-A-01
- Rev
- A
- Issued
Product specification sheet · Quick install
Printed Drive Parts
Spool, worm wheel, and drive gears — matched set of 5
The moving printed parts, sold as one set because a gear train wears as one. The N52 encoder magnets arrive already pressed into the worm wheel.
P/NTF-D-PRT-01SKUTF-D-PRT-01RevA
| Set contents | 5 parts — spool, worm wheel, drive gears |
|---|---|
| Encoder magnets | 2 × N52, pre-pressed into the worm wheel |
| Finish | Production gray |
| Also available as | STLs in TiltForge Studio (TF-D-STL-01) |
Features
- Sold as a matched set. Replacing one worn gear against four worn ones just moves the wear. A fresh set is the actual repair.
- Magnets already in. The two N52 encoder magnets come pressed into the worm wheel, oriented and ready for the AS5600 to read.
- Drives the axis the blind already uses. The spool and worm sit on the same axis as the headrail’s own worm gearing, which is what keeps your pull cord working.
- Printable, forever. Every part here is in the STL set. If TiltForge disappears tomorrow, you can still make one.
- An hour, not a service call. The whole set is the cheapest part of the unit. Wear is designed to land here on purpose.
How to use it
Copy pendingInstall and use instructions for this part are being written against the final production build. The sheet format below is final — the steps are not written yet.
Assembly and installation steps for this part have not been published yet.
© 2026 TiltForge. All rights reserved. TiltForge and the TiltForge gear mark are trademarks of TiltForge. Specifications are subject to change without notice — this sheet documents Rev A, and the current revision is always at https://www.tiltforge.com/p/drive-parts.