STL downloads
Build itPrint it
Print your own parts
Every printed part of the TiltForge, free and ready for your slicer, and a library of remixes and add-ons from people who build them. Print it first and see if it fits your blind before you spend anything. Made something that fits a blind we didn't plan for? Share it.
Official parts
Release 2026-11-21 · CC BY-NC-SA 4.0- Shell A× 101_shell_A.stl
Stand it on the USB end face.
- Shell B× 102_shell_B.stl
Open side up.
- Lip clip× 103_lip_clip.stl
Profile flat on the bed.
- Worm, 4-start× 104_worm.stl
Upright, axis vertical. 5 mm brim.
- Rod gear, 20T× 105_rod_gear.stl
Socket face down. 5 mm brim.
- Axle, 6 mm hex× 106_axle.stl
On a hex flat.
- Axle spur gear, 23T× 107_axle_spur_23T.stl
Plain face down, small hub boss up.
- Motor spur gear, 19T (clutch)× 108_motor_spur_19T.stl
Gear face down.
- Cord reel× 109_reel.stl
On its side on the 1 mm flat. No supports, 5 mm brim.
- Crown (magnet holder)× 110_crown.stl
Brim down. The pocket fits a Ø4.7 × 3 mm diametric magnet.
- Button plunger× 111_button.stl
Foot down. 3 mm brim.
- Rod adapter, 1/4" Dpick one12_rod_adapter_quarter_D.stl
Print the one adapter that fits your tilt rod.
- Rod adapter, 1/4" hexpick one13_rod_adapter_quarter_hex.stl
Print the one adapter that fits your tilt rod.
- Rod adapter, 7/32" hexpick one14_rod_adapter_7-32_hex.stl
Print the one adapter that fits your tilt rod.
- Rod adapter, 5.72 mm squarepick one15_rod_adapter_5p7_square.stl
Print the one adapter that fits your tilt rod.
Print each part once; for the rod adapter, print only the one that fits your tilt rod (or make one for your exact rod). The screws, bearings, magnet and clutch hardware are all off the shelf. The build guide walks through putting it together. CC BY-NC-SA 4.0 means you can remix and share these with credit, just not sell them. The same files are on MakerWorld, with a one-plate 3MF.
From the community
Share a designNothing here yet. Printed an adapter for an odd tilt rod, a bracket for a deep headrail, or a better cord reel? Be the first to share it. Already posted it on Printables, Thingiverse or MakerWorld? Just send the link.
Community designs are made and maintained by their makers, not TiltForge. Check the fit before you print a batch.