Firmware
Fix itUpdates
Update your TiltForge
Plug the unit into a computer, click two buttons, and it restarts on the new firmware. It runs in Chrome or Edge on a Mac or PC with nothing to install.
Updating only replaces the program. Your pairing, Wi-Fi, HomeKit setup and calibration stay on the unit, so it comes back exactly where it was.
Flash it
- Plug the unit into this computer with a USB-C data cable.
- Click Update firmware and pick the port that appears (it is usually named USB JTAG/serial debug unit).
- Leave it plugged in until it says Done. It takes about a minute.
0.12.4, 2.8 MB
Releases
- Each unit now gets its own network name from its hardware address. Before this, every unit called itself tiltforge-e658, so a second unit on the same network clashed with the first. Existing units pick up their new name after the update.
- The motor now stops as soon as it reaches the end of travel instead of slipping the clutch until it times out. If it stalls partway, it stops and reports a jam.
- The web control page responds right away (Wi-Fi power saving is off) and now shows Wi-Fi signal strength.
- New “Button on device” setting, under the LED option, ignores the physical button if it gets pressed against the window sill. To turn the button back on without the web page, hold it while plugging the unit in.
SHA-256 d28b1198b7f5207725a63b50fda9b37ced142806ce5d02bab6228c0d382aac39
If it won't connect
- Use a USB-C cable that carries data. Many charging cables don't, and the port picker will show nothing. The cable in the box works.
- Plug straight into the computer rather than through a hub or dock.
- Close anything else that might be holding the port: the Arduino IDE, a serial monitor, or another browser tab running a flasher.
- Still stuck: unplug the unit, hold the small B (BOOT) button on the controller board, plug it back in, then let go and click Update firmware again.
- Phones and tablets can't do this. iPhone and iPad have no USB serial access in any browser, and Safari and Firefox don't support it on desktop either.
Coming back from custom firmware
This page updates a unit that is already running TiltForge firmware. If you erased the chip to try ESPHome or your own build, the Matter pairing data that was written at the factory went with it, and an update alone won't bring it back. Email support@tiltforge.com with your unit ID and we'll sort it out. More on what's covered is in the firmware policy.