Documentation

Part specification sheets

One sheet per part: what it is, what it does, and how to put it in. Each one prints to a single page and doubles as the quick-install guide that ships with the part.

Sheets are addressed by design revision, so the QR printed on a part in 2026 still opens the sheet that describes that part after the design moves on. Put /p/pcb-rev-d on labels; /p/pcb follows the current revision and is for anything you can reprint.

• TiltRod Control Board

  v3.0 Rev D — 21.5 × 40 mm

  TF-SS-PCB-D-02 · Rev D

• XIAO ESP32-C6 Controller

  Pre-flashed with TiltForge firmware

  TF-SS-C6-A-02 · Rev A

• N20 Gearmotor and Clutch

  N20, 298:1, custom M4 shaft to drawing TF-D-MTR-01 — with the friction clutch that threads onto it

  TF-SS-MTR-A-04 · Rev A

• Printed Drive Parts

  Worm axle, gears, spool, rod adapters and eye screw — the whole moving set

  TF-SS-PRT-A-04 · Rev A

• Printed Case

  Both shell halves and the button, in white

  TF-SS-ENC-A-03 · Rev A